|
| |
TM 9-2330-398-24
2-106. ENGINE OIL FILTER REPLACEMENT (continued).
b. INSTALLATION
1.
Coat gasket on new filter (1) with clean oil. Install filter (1) on mounting shaft of engine.
2.
Hand-tighten filter until gasket touches mounting shaft. Tighten an additional half-turn. DO NOT overtighten.
3.
Refer to lubrication chart (Appendix G) for correct type of oil.
4.
Remove oil fill cap (2) from engine. Inspect gasket in oil fill cap (2) and replace if damaged.
5.
Add pint of oil to crankcase. Install oil fill cap (2) on engine and check oil level.
FOLLOW-ON MAINTENANCE:
• Disconnect ground (refer to TM 92330-398-10).
2-223
|
