|
| |
TM 9-2330-398-24
2-24.
LUBRICATION INSTRUCTIONS.
To prevent corrosion, apply a light coat of lubricating oil to metal parts after they are cleaned but before they are
assembled. Lubricate components and systems in accordance with the instructions in PMCS, Table 2-1, and Appendix G.
2-25.
TORQUE VALUES.
Torque values given in the maintenance procedures apply to unlubricated threads. Follow the torque values given in the
maintenance procedures; if no torque value is given, refer to Appendix E.
2-26.
DECAL REPLACEMENT.
WARNING
Dry-cleaning solvent P-D-680 is toxic and flammable. Always wear protective goggles and gloves,
and use only in a well-ventilated area. Avoid contact with skin, eyes, and clothing, and DO NOT
use near open flame or excessive heat.
NOTE
For proper installation of a decal, note its location before removing.
a.
Use dry-cleaning solvent to loosen damaged decal, and remove decal from surface. Discard decal.
b.
Clean any decal residue from surface with dry-cleaning solvent. Wipe surface with clean rag.
NOTE
Surface must be clean and dry before installing new decal.
c.
Remove protective backing from new decal and position on surface.
d.
Using a dry rag (Item 25, Appendix C), press decal into position. Start in the center of decal and press outward to
remove any air bubbles.
2-69
|
