|
| |
TM 9-2330-272-14
2-15. OPERATING AUXILIARY ENGINE.
a. Starting.
NOTE
Auxiliary engine operation is the same for all models; location may vary. M131A5 is
illustrated. Refer to paragraphs 1-7 and 2-2 for location of engine controls on other
models.
(1) Ensure that fuel shutoff cock on sediment strainer (4) is open.
(2) Pull out on choke control (6).
(3) Set panel power switch (7) and ignition switch (8) to ON position.
WARNING
DO NOT slave start auxiliary engine. Slave starting may cause battery to spark and
cause explosion. Failure to follow this warning may result in injury to personnel.
(4) Press starter button (1). If engine (5) does not start within five seconds, release button and wait a few
seconds before pressing again. If engine does not start after four or five attempts, perform troubleshooting (Chapter 3,
Section II).
TA702651
2-26
|
