|
| |
TM 9-2330-272-14
5-6.
CROSS TUBE AND MOUNTING BRACKET REPLACEMENT (Con’t).
2.
Measure cross tube outer diameter at outer
bearing mounting surface (14). Discard cross tube
(1) if measurement is less than 3.3 in. (8.4 cm).
3.
Measure cross tube outer diameter at inner
bearing mounting surface (15). Discard cross tube
(1) if measurement is less than 3.5 in. (8.9 cm).
c. INSTALLATION
1.
Position mounting bracket (4) on frame and install eight screws (7) and new locknuts (6).
2.
Install eight screws (5) and new locknuts (8) on mounting bracket (4) and frame.
3.
Repeat steps 1 and 2 for mounting bracket (4) on other side.
4.
Install two brackets (9) on cross tube (1) with two new Iockwashers (12), screws (13), and nuts (2).
5.
Install cross tube (1) and two brackets (9) on two mounting brackets (4) with eight screws (3), new Iockwashers
(11), and nuts (10).
TA702855
5-13
|
