|
| |
TM 9-2330-272-14
4-88. FILTER-SEPARATOR SERVICING (M131A5C LATE MODEL) (Con’t).
8.
Repeat steps 5 through 7 for four remaining canister (7) assemblies.
9 .
Remove 15 retainers (13) from elements (14).
10.
Remove 15 elements (14) from guide pipes in filter-separator (1).
1.
Clean all parts with a clean rag.
2.
Inspect elements and fuses for damage. Replace damaged parts.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
Install 15 elements (14) on guide pipes in filter-separator (1) beginning with guide pipes farthest from service
port.
Install 15 retainers (13) on elements (14) and handtighten only. Do not overtighten.
Install new gasket (10) on adapter (11).
Install three fuses (9) in adapter (11). Push elements into holes and install fuse clip (8) on fuses. Install new
gasket (12) on adapter.
Slide canister (7) over fuse (9) assembly and push canister into adapter (11).
Repeat steps 3 through 5 to assemble four remaining canister (7) assemblies.
Insert canister (7) assembly through service port with adapter (11) end down toward bottom of tank. Turn adapter
end left and lift canister assembly into position on upper guide pipes farthest from service port. Slide canister
assembly to left until it fits into the outlet hole.
Raise end of canister (7) assembly and install spacer wire (6) near end of canister.
Install next canister (7) assembly on upper guide pipes, followed by lower row starting with the farthest
installation away from service port. Install remaining spacer wires (6).
NOTE
Handtighten wingnuts. Do not use a wrench.
Install retainer plate (5) with eight washers (2), four new Iockwashers (3), and wingnuts (4).
Position new preformed packing (18) and cover (17) on filter-separator (1) and install clamp (15). Tighten screw
(16).
4-187
|
