|
| |
TM 55-4920-383-13&P
(1) Attach two handles (62, figure 3-4) to panel subassembly (61) using four screws
(60).
(2) Mount four internal coaxial cable assemblies (48, 53, 57 and 58) and four flat
washers (47, 52, 55 and 59) on panel subassembly (61) and secure using four hex nuts (10,
8, 6 and 1).
(3) Mount two internal coaxial cable assemblies (49 and 57), two flat washers (51 and
56) and two gaskets (50) on panel subassembly (61) and secure using two hex nuts (9 and 5).
(4) Mount six protective caps (2, 4 and 7) on connectors of six internal coaxial cable
assemblies (48, 49, 53, 54, 57 and 58). Secure chains of protective caps to panel subassem-
bly (61) using four screws (3).
(5) Attach connector (36), gasket (37) and chain of protective cap (34) to panel sub-
assebmly (61) using four screws (35). Mount protective cap (34) on connector (36).
(6) Install binding post (38) on panel subassembly (61) using O-ring (39) and flat
washer (40) and two hex nuts (41).
(7)
nuts (42).
(8)
Mount two fuseholders (31) on panel subassembly (61) and secure using two hex
Install two fuses (32 and 33) in fuseholders (31).
Install lampholder (13) in panel subassembly (61) and secure using flat washer (43)
and hex nut (44). Install lamp (12) in lampholder (13).
(9) Install toggle switch (45) and seal washer (46) on panel subassembly (61) and secure
using hex nut (9).
(10) Mount two binding posts (25 and 27), two gaskets (29) and two washers (28)
panel subassembly (61) and secure using four hex nuts (30).
(11) Install pushbutton switch (26) on panel subassembly (61) and secure using hex
nut (18).
(12) Install two potentiometers (23 and 24) on panel subassembly (61) and secure using
4-27
|
