|
| |
TM 55-2915-335-30&P
2-20. PUMP-END BRUSH HOLDER ASSEMBLY - lNSPECT/REPLACE/REPAIR (Cont)
2-20
5. ASSEMBLY
a. New brushes (10) are not equipped with terminal lugs (13 or 14). If replacing brushes, install new terminal lugs
before assembling brush holder assembly. Cut brush shunt leads off at 7/8 inch (22 mm) from brush body,
b.
c.
Crimp on new terminal lugs.
Install brush springs (11) on brush holder studs. Place straight spring end on keeper ledge. Install brush holder
cover (9). Install and tighten nuts (8).
Using a hooked wire, pull spring end out of brush holder slot. Slide brush (10) halfway into brush holder slot.
AlloW hooked end of brush spring to rest against side of brush, as shown. Be careful not to chip or damage
brush.
Insert brush shunt lead terminal lugs up through holes in cover (9).
GO TO NEXT PAGE
2-70
|
