FILLER/DISCHARGE ASSEMBLY MAINTENANCE.

TM 5-5430-226-12

4-16. FILLER/DISCHARGE ASSEMBLY MAINTENANCE.

This task covers:

a. Removal

d. Inspection

g. Installation

b. Disassembly

e. Repair

c. Cleaning

f. Assembly

INITIAL SET-UP:

Tools required:

Tool Kit, General Mechanics, Automotive (Appendix B, Sec. III, item 1)

Torque Wrench (0-50 Inch-Pounds) (Appendix B, Sec. III, item 2)

Materials/Parts required:

Detergent, General Purpose (Item 1, Appendix D)

Rag, Wiping (Item 2, Appendix D)

Tape, Anti-seize (Item 3, Appendix D)

Coupling Gaskets (4) - MS27030-9

Gasket - C2479M-4

O-ring- MS9021-383

Equipment Condition:

Water tank empty.

NOTE

The filler and discharge assemblies are similar. Only the 90elbows are different. All procedures

apply to both assemblies.

a. Removal.

(1) Open locking arms on discharge elbow (1). Separate elbow from fanged coupling (14).

(2) Open locking arms on filler elbow (17). Separate elbow from fanged coupling (14).

b. Disassembly.

(1)

Remove gaskets (16 and 18) from filler elbow (17).

(2)

Remove gasket (2) from discharge elbow (1).

(3)

Remove twenty bolts (12),washers (l 1) and dust cap (3) from closure plate (5).

(4)

Separate closure plate (5) and attached parts from compression fitting (20). Remove o-ring (7).

4-14