|
| |
TM 5-5430-219-13
ASSEMBLY (See figure 3-16.)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Place gasket (16) into dust cap (17).
Place elbow gasket (4) into elbow (1).
Place suction stub (14) on flat hard surface with bolt holes on top.
Place thread seal washers (13) over each bolt hole in suction stub
( 1 4 ) .
Place closure plate (7) on top of thread seal washers (13) being
careful to keep all holes aligned.
Place flanged adapter gasket (15) on closure plate (7) and align holes.
Place flanged adapter (3) on flanged adapter gasket (15) and align
h o l e s.
Insert screws (12) through holes in flanged adapter (3) and thread
until screw ends protrude through suction stub (14).
Assemble lockwashers (11) and nuts (10) to screws (12) and torque to
30 ft-lb (40.95 N•m).
Lubricate preformed packing (9) with silicone compound and place in
packing groove in collapsible tank fitting.
Place closure plate (7) and attached components on tank and insert
suction stub (14) through opening in tank until closure plate (7)
contacts tank fitting (8).
If tank is lying completely flat, lift tank to closure plate (7) to start
screws (5) in tank fitting (8).
Assemble washers (6) on screws (5) and insert screws through closure
plate (7) and in tank fitting (8).
Torque to 30 in-lb (3.41 N•m).
Place elbow (1) on flanged adapter (3). Pull inward on cam-lever arms
(2) to lock items together.
3-37
|
