|
| |
TM5-4930-235-13&P
(c) Install snap ring (39) in groove of nozzle body (47). Check to be sure snap ring is completely
seated in groove.
(d) Carefully insert regulator sleeve (34) through seal (41). Rotate regulator sleeve (34) to check for
uniform drag. Non uniform drag indicates seal (41) is not installed correctly.
(e) Remove regulator sleeve (34).
(7) Install seal (37) on regulator sleeve (34) with spring side facing away from backup ring (36) side.
CAUTION
Do not clamp parts in a vise. Do not use an extension or cheater bar with spanner wrench.
Failure to comply can result in damage to parts.
(8) Install backup ring (36) on regulator sleeve (34). Install snap ring (35) in groove of regulator sleeve (34).
CAUTION
Clamp vise only on flats of strainer housing. Do not over tighten vise. Failure to comply can
result in damage to strainer housing.
(9) Put nozzle body (47) in vise with outlet end pointing up.
(10) Install spring (38) and regulator sleeve (34) in nozzle body (47). Snap ring (35) must be on top.
(11) Install regulator tool as follows:
(a) Insert regulator tool through bottom of nozzle body (47).
(b) Place front plate of regulator tool on regulator sleeve (34) with small face down. (See Figure 5-8.)
(c) Align regulator sleeve (34, Figure 5-2) with seal (39) in nozzle body (47).
(d) Pull down on handle and position rear plate against bottom of nozzle body (47). Insert cotter pin in
hole of rod.
(e) Slowly release handle to lock regulator tool in place.
(12) Install seals (1 and 32) in latch adapter (33). Spring side must face threaded end of latch adapter (33).
(13) Install latch adapter (33) and related parts as follows:
(a) Thread latch adapter (33) into nozzle body (47) until one to two threads are engaged.
(b) Slide spring (28) over latch adapter (33) and against nozzle body (47).
(c) Insert one spring (31) in groove of each release pin (29).
(d) Slide pullback sleeve (27) over latch adapter (33) and align slot with spring pin (44). Push pullback
sleeve (27) down against nozzle body (47) and hold in place.
(e) Install spring (31) and release pin (29) assemblies in grooves of latch adapter (33).
5-16
|
