|
| |
TM 5-4930-234-13&P
(a)
Remove large locating nut from end of threaded rod.
(b)
Push down on pressure regulator sleeve (35) until it passes pressure regulator seals (46 and 47).
(c) Slide threaded rod through pressure regulator sleeve (35) until end extends out the bottom of body
(49).
(d)
Thread locating nut on end of threaded rod and hand-tighten until pressure regulator (35) has 1/4
inch of travel. See Figure 5-14.
16.
Install pullback sleeve spring (37) in pullback sleeve (34).
17.
Install pullback sleeve (34) and adapter (43) on body (49). Push down on pullback sleeve (34).
18.
Thread adapter (43) into body (49) using adapter torque tool, S1391-7, and a torque wrench. Tighten to
a torque of 40-50 ft-lbs. See Figure 5-15. Remove adapter torque tool.
19.
Remove large locating nut from end of threaded rod. Remove regulating positioning tool, S1391-9, from
body (49).
Figure 5-13. Body Installation.
Figure 5-14. Tool Installation
5-21
|
