|
| |
TM 5-4930-234-13&P
b.
Disassembly. Cut cable (6) near sleeve (5) at dust cap (4) and remove.
NOTE
Clean parts with a clean cloth to remove dust, dirt, fuel or grease.
c.
Inspection.
1.
Inspect dust cap (4) for corrosion, cracks, or distortion.
2.
Inspect cable (6) for corrosion, cuts, or fraying.
d.
Replacement. Replace any damaged parts.
e.
Reassembly.
1.
Slide sleeve (5) down cable (6).
2.
Insert one end of cable (6) through hole in dust cap (4).
3.
Make a one inch loop with the cable (6) and slide sleeve (5) over end of cable (6).
4.
Crimp sleeve (5) in place on cable (6).
5.
Repeat steps 1 through 4 for other end of cable (6).
f.
Installation.
1.
Install dust cap (4) on outlet end of nozzle (1).
2.
Install end of cable (6) on ring (3).
4-7.
DUST PLUG ASSI4BLY (See Figure 4-2).
a.
Removal.
1.
Hold nozzle (1) and pull cam arms (2) away from nozzle (1).
2.
Remove dust plug (4) from end of nozzle (1).
3.
Remove cable (6) from ring (3) on nozzle (1).
b.
Disassembly. Cut cable (6) near sleeve (5) at dust plug (4) and remove.
NOTE
Clean parts with a clean cloth to remove dust, dirt, fuel or grease.
c.
Inspection.
1.
Inspect dust plug (4) for corrosion, cracks, or distortion.
4-5
|
