|
| |
TM 5-4320-313-14
5-11.
PISTON.
This task consists of:
a. Removal b. Disassembly c.Cleaning d.Inspection
e. Repair f. Installation
INITIAL SETUP:
Tools Required:
Tool Kit, General Mechanics (item 1, appendix B)
Pliers, Retaining Ring (item 2, appendix B)
Piston Ring Clamp (item 22, appendix B)
Micrometer (item 3, appendix B)
Materials Required:
Rags, Wiping (item 8, appendix E)
Solvent, Cleaning (item 10, appendix E)
General Safety Instructions:
Well-ventilated area required.
Equipment Conditions:
Cylinder removed in accordance with paragraph 5-10.
a. Removal.(Refer to figure 5-27).
(1) Using retaining ring pliers remove circlip (1).
CAUTION
When removing piston, make sure piston or connecting rod does not knock against crankcase. This
could result in serious damage to piston or connecting rod.
(2) Press gudgeon pin (2) from piston (3). Remove piston (3) from connecting rod (4). Remove other circlip
(1).
5-40
|
