|
| |
TM 5-4320-313-14
4-17. THROTTLE.
This task consists of:
a. Removal
b. Installation
c. Adjustment
INITIAL SETUP:
Tools Required:
Tool Kit, General Mechanics (item 1, appendix B)
Allen Socket (item 24, appendix B)
Equipment Conditions:
Pumping assembly shut down in accordance with paragraph 2-6.
a. Removal. (Refer to figure 4-10).
(1) Remove nut (1), disc (2), and nut (3). Remove lever (4).
(2) Loosen nuts (5 and 6). Unscrew angular joint (7) from adjusting screw (10).
(3) Remove nut (8). Unscrew angular joint (9) from adjusting screw (10).
(4) Remove two screws (11). Remove console (12) and four discs (13).
(5) Remove two nuts (14), disc (15), and spring washer (16).
(6) Remove hand lever (17), lever (18), and screw (19).
(7) Remove two screws (20), two discs (21), two nuts (22), and two fixing flaps (23).
b. Installation.
(1) Install two screws (20), two discs (21), two nuts (22), and two fixing flaps (23).
(2) Install screw (19) into console (12).
(3) Install hand lever (17) on screw (19) and engage tang on hand lever (17) with notch on
lever (18).
(4) Install flat washer (16), disc (15), and nut (14). Tighten two nuts (14) until lever has a
slight drag.
(5) Install two discs (13) and console (12).
(6) Install two screws (11). Tighten securely.
4-24
|
