|
| |
TM 5-4320-313-14
4-14. FUEL LINES, HOSES, AND FITTINGS.
This task consists of:
a. Removal
b. Inspection
c. Installation
INITIAL SETUP:
Tools Required:
Tool Kit, General Mechanics (item 1, appendix B)
Allen Socket (item 24, appendix B)
Equipment Conditions:
Pumping assembly shut down in accordance with paragraph 2-6.
a. Removal. (Refer to figure 4-7).
(1) Remove hose (1), clamp (2), and hose (3).
(2) Remove bolt (4), flat washer (5), banjo fitting (6), and two flat washers (7).
(3) Remove screw (8), two screws (10), two flat washers (9), four clamps (11), and spacer
(12).
(4) Remove screw (13), flat washer (14), clamp (15), and two spacers (16).
NOTE
Place a suitable container under engine and drain fuel from fuel tank.
(5) Remove hoses (17, 18, and 19).
(6) Remove two bolts (20), four flat washers (21), and two banjo fittings (22).
b. Inspection.
(1) Inspect all hoses for cracks or signs of fraying.
(2) Inspect all hardware for damaged threads.
c. Installation.
(1) Install two banjo fittings (22) and four flat washers (21) and secure with two bolts (20).
(2) Install hoses (19, 18, and 17).
4-18
|
