|
| |
TM 5-4320-313-14
CHAPTER 4
UNIT MAINTENANCE INSTRUCTIONS
Section I Lubrication Instructions
Section II Repair Parts, Special Tools, TMDE, and Support
Equipment
Section III Service Upon Receipt of Equipment
Section IV Preventive Maintenance Checks and Services
(PMCS)
Section V Troubleshooting
Section VI Maintenance Procedures
Section VII Preparation for Storage or Shipment
Section I. LUBRICATION INSTRUCTIONS
4-1.
LUBRICATION INSTRUCTIONS.
a. Engine. (Refer to figure 4-1).
(1) Every 150 hours of operation change engine oil. Use Oil, Engine, MIL-L-2104D (item 6,
appendix E).
(a) Remove engine oil drain plug (2) and allow oil to drain into a suitable container.
Install oil drain plug (2) and new washer (3).
(b) Remove engine oil cap (4) and fill engine sump with MIL-L-2104D to "Top Mark" on
dipstick (1). Crankcase capacity is 0.26 gallon (1 liter).
b. Engine (Lubrication in Sandy Areas). During operation in sandy areas, engine oil should be
changed every 100 hours. Refer to paragraph 4-1a. And change engine oil.
c. Pump. The pump does not require lubrication.
4-1
|
