|
| |
TM 5-4320-313-14
2-5.
ASSEMBLY AND PREPARATION FOR USE - Continued.
a. General Precautions - Continued.
(2) Do not smoke or use open flame in vicinity of fuel tank.
b. Siting.
WARNING
Weight of pumping assembly is 196 lbs (88.98 kgs). Four persons are required for lifting pumping
assembly.
(
(1) Select a site that will provide relatively level terrain to locate the pumping assembly. Clear away dry leaves,
grass, and brush from the ground where the pumping assembly will be located.
(2) Position the pumping assembly and filter/separator assemblies for desired fueling operation.
(3) Refer to figures 2-2 and 2-3 for setting up a refueling operation.
WARNING
Extreme care must be taken to prevent injury to fingers or hands when driving the ground rods. Do
not place hands between the ram and drive collar. Gloves should be worn.
(4) Remove ground rod from filter/separator and drive it into the ground at least 3 ft. Connect ground cables from
pumping assembly and filter/separator to the ground rod.
(5)Perform (B) Before operation PMCS contained in table 2-1.
Figure 2-2. Setting Up Refueling Operation.
2-6
|
