|
| |
TM 5-4320-313-14
6-5. OIL SEAL (FLYWHEEL SIDE).
This task consists of:
a.
Removal
b.
Cleaning
c.
Inspection
d.
Installation
INITIAL SETUP:
Tools Required:
Tool Kit, General Mechanics (item 1, appendix B)
Shop Set, Automotive Repair, Field Maintenance, Basic (item 3, appendix B)
Auxiliary Bushing, Oil Seal (60 x 75 mm dia) Support Flywheel Side 666 068 00
(item 13, appendix B)
Materials Required:
Grease (item 4, appendix E)
Oil Seal, P/N 40034200
Packing, P/N 50154000
Rags, Wiping (item 8, appendix E)
Solvent, Cleaning (item 10, appendix E)
General Safety Instructions:
Well-ventilated area required.
Equipment Conditions:
Flywheel removed in accordance with paragraph 5-12.
Cranking gears removed in accordance with paragraph 5-8.
a. Removal. (Refer to figure 6-11).
(1) Bend tabs of plates (2) away from screws (1).
(2) Remove four screws (1) and two plates (2).
(3)
Remove cover (3) and packing (4). Discard packing (4).
(4) Remove seal (5) from cover (3). Discard seal (5).
b. Cleaning.
WARNING
Do not breathe cleaning solvent P-D-680 vapors for long periods of time or use solvent near open
flames. To avoid illness, explosion, or fire, only use solvent in well-ventilated areas away from open
flames.
(1) Clean cover with a rag and cleaning solvent.
(2) Allow to dry.
6-18
|
