|
| |
TM 5-4320-308-13
Section VI. MAINTENANCE PROCEDURES
INDEX
Para
Para
Adapter shaft
3-20
Ground rod
3-18
Air cleaner
3-22
Impeller
3-20
Air filter assembly
3-22
Muffler
3-28
Check valve assembly
3-19
Nozzle assembly
3-16
Cold start assist
3-24
Pump case assembly
3-21
Cylinder head and valve assembly
3-30
Shaft seal
3-20
Discharge hose assembly
3-13
Storage container
3-15
Drum unloader assembly
3-14
Suction hose assembly
3-12
Fuel filter
3-25
Three-way valve
3-23
Fuel lift pump
3-26
Throttle control
3-29
Fuel lines, hoses, and
3-25
Volute
3-20
fittings
Wear plate
3-20
Fuel tank
3-27
Y-Connectors
3-17
3-11. GENERAL INSTRUCTIONS
Maintenance instructions in this section will list resources required, personnel required, and equipment condition for the
start of the procedure. Note the following:
Resources required are not listed unless they apply to the procedure.
Personnel required are listed only if the task requires more than one. If PERSONNEL is not listed, it means one
person can do the task.
The normal standard equipment condition to start a maintenance task is engine stopped. EQUIPMENT
CONDITION is not listed unless some other condition is required.
Refer to Appendix F to determine torque requirements when tightening threaded fasteners, unless a specific
torque value is given in procedure. Standard torque values given in Appendix F are determined by thread size.
3-32
|
