|
| |
TM 5-4320-308-13
5-6. REPLACE OIL SEAL (FLYWHEEL SIDE) (Continued)
CLEANING/INSPECTION:
WARNING
Death or serious injury could occur if fuel is not handled carefully. Use in a well-ventilated area
away from open flame, arcing equipment, ignition sources, heaters, or excessive heat. Always
store fuel in proper, marked containers. DO NOT SMOKE
Death or serious injury could occur if compressed air is directed against the skin. Do not use
compressed air for cleaning or drying unless the pressure is/has been reduced to 30 psi (2. 06
bar) or less. When working with compressed air, always use chip guards, eye protection, and
other personal protective equipment
1 Clean oil seal components with diesel fuel and dry with compressed air
2 Inspect all components for damage or excessive wear. Replace any components severely damaged or worn
INSTALLATION:
1 Install auxiliary bush 666 068 00 in crankshaft
2 Install oil seal (5) into support (1)
3 Fill groove of oil seal (5) with grease.
4 Lubricate new preformed packing (4) with grease and install it in preformed packing groove in support (1).
5 Install support (1) onto crankshaft with two security plates (2) and four hex screws (3).
6 Remove auxiliary bush 666 068 00.
5-20
|
