|
| |
TM 5-4320-308-13
4-8. REPAIR NOZZLE ASSEMBLY (Continued)
9
Remove cable (30) by removing plug screw (31) from body (5).
10
Remove bushing (3) from body (5).
CLEANING/INSPECTION:
WARNING
Death or serious injury could occur if fuel is not handled carefully. Use in a well-ventilated
area away from open flame, arcing equipment, ignition sources, heaters, or excessive heat.
Always store fuel in proper, marked containers. DO NOT SMOKE.
Death or serious injury could occur if compressed air is directed against the skin. Do not use
compressed air for cleaning or drying unless the pressure is/has been reduced to 30 psi (2.06
bar) or less. When working with compressed air always use chip guards, eye protection, and
other personal protective equipment.
1
Clean all components with clean diesel fuel and dry with compressed air.
2
Inspect all components for wear, cracks, leaks, signs of deterioration, damaged threads, and obvious damage.
Replace damaged components.
ASSEMBLY:
1
Install bushing (3) into body (5).
2
Attach ground wire plug (28) and clip with screw (29) to cable (30).
3
Attach cable (30) to body (5) with plug screw (31).
4
Install new preformed packing (27). Attach spout assembly (25) and nozzle strainer assembly (26) to body (5).
5
Attach two cap chain links (20), chain (21), two drawbars (22), and compression spring (23) to cap (24) and body
(5).
6
Attach lever (17) with two pushnuts (18) and pin (19) into body (5).
7
Install new packing (16), packing nut (14), and packing gland (15) into body (5).
8
Install stuffing box (13), stem (12), nut (11), lower disc washer (10), lower disc (9), lower disc holder (8), upper
poppet (7), and spring (6) into body (5).
9
Attach cap (4) to body (5).
10
Attach dust cap (1) to coupler (2). Attach dust cap and coupler to bushing (3).
4-15
|
