|
| |
TM 5-4320-306-24
4-4. REPAIR INJECTION PUMP (Continued)
DISASSEMBLY
1
Mount fuel injection pump in vise.
2
Place an oil drain container under governor housing
3
Remove two bolts (1) and two bolts (2)
4
Remove cover (3) and drain oil into container.
5
Remove sealing plate (4), intermediate plate (5), and gasket (6).
6
Remove nut (7)
7
Remove torque capsule (8) using torque capsule wrench KDEP 2968
8
Remove cap nut (9) and washer (10).
9
Remove nut (11) and washer (12)
10 Remove setscrew (13).
11 Remove lead seal (14) and cap (15).
12 Remove nut (16) and adjusting screw (17)
13 Remove four screws (18) and two bolts (19).
14 Loosen governor cover (20) from governor housing using a rubber mallet. Swing open but do not remove governor
cover.
4-6
|
