|
| |
TM 5-4320-306-24
3-17. TEST/REPAIR STARTER MOTOR (Continued)
ASSEMBLY:
1
Install bushing (36) into drive end shield (37).
2
Install bushing (31) into intermediate bearing (30).
3
Install intermediate bearing (30), overrunning clutch drive (32), bushings (35), stop ring (34), and retainer (33) on
armature (24). Install this assembly into drive end shield (37).
4
Install fork lever (29) and secure with screw (27), spring washer (28), and nut (26).
5
Install studs (25).
6
Install excitation winding (23).
7
Install bushing (22) into commutator end shield (16).
8
Install carbon brushes (21) into brush holder (17) and secure with screws (20) and nuts (19).
9
Install brush holder (17) with compression springs (18).
10
Install commutator end shield (16) and secure with washers (15) and nuts (14).
11
Install shims (12 and 13), locking washer (11), and seal ring (10) on armature shaft.
12
Install closure cap (9) and secure with screws (8).
.
13
Install solenoid switch (6) into drive end shield (37) and secure with screws (7).
14
Attach wire (5) (solenoid switch to excitation winding) to solenoid switch (6).
15
Install lockwashers (4) and nuts (3).
16
Install clamping saddle (2) and screw (1).
3-85
|
