|
| |
TM 5-4320-306-24
3-16. REPAIR TURBOCHARGER (Continued)
ASSEMBLY:
1
Lubricate bearings (24 and 26) and shaft of
shaft and turbine wheel assembly (11) with
lubricating oil.
2
Clamp down shaft and turbine wheel assembly
(11) at hub.
3
Install piston rings (28) in groove. Install with
gaps offset through 90 degrees toward oil inlet.
4
Install new snap rings (25) and bearing (26) in bearing housing (2).
5
Install heat shield (27) on bearing housing (2).
6
Install bearing (24) and new snap rings (23) in bearing housing (2).
7
Install bearing housing (2) carefully over shaft.
8
Install thrust ring (22), thrust bearing (21), and oil deflector (20) in bearing housing (2).
9
Install spacer sleeve (19), flinger sleeve (18), and piston rings (17).
3-77
|
