|
| |
TM 5-4320-306-24
2-39. REPLACE FUEL TANK LINES AND FITTINGS (Continued)
9 Loosen line nuts (1) on injectors (2) one full turn.
10 Hold a lint-free cloth below injectors (6) to collect
leakage.
CAUTION
To prevent starter from overheating, do
not crank engine with starter for more
than 10 seconds.
Battery life will be lengthened if 60
seconds is allowed to elapse between
starting attempts.
Under any condition, if engine does not
start on initial attempt, allow engine
rotation to stop completely before again
engaging starter.
11 Set MANUAL THROTTLE CONTROL to maximum engine speed.
12 Press and hold in the OIL BY-PASS switch, set START/STOP switch to START, push up STARTER switch and
observe fuel flow from injector fittings until air is cleared from lines Release OIL BY-PASS switch.
13 Tighten line nuts (1) on injectors (2)
14 Start engine
2-138
|
