|
| |
TM 5-4320-306-24
2-24. REPLACE THROTTLE CONTROL VERNIER (Continued)
6
Loosen nut (9) and washer (10) on back of throttle panel (11).
7
Remove throttle control knob and vernier (12) through front of throttle panel (11).
CLEANING/INSPECTION:
WARNING
Death or serious injury could occur if diesel fuel oil is not handled carefully. Use in a well-
ventilated area away from open flame, arcing equipment, ignition sources, heaters, or excessive
heat. Always store fuel in proper, marked containers. DO NOT SMOKE.
1
Check that inner throttle cable moves freely within the outer sheath. Inspect for rust, corrosion, or stripped or
damaged threads.
2
Clean throttle control lever extension, fittings, and hardware with diesel fuel oil.
3
Replace any severely damaged parts.
INSTALLATION:
1
Install throttle control knob and vernier (12) through front of throttle panel (11).
2
Connect one end of throttle cable (6) at quick release (8) at back of throttle panel (11)
3
Slide other end of throttle cable (6) into slot on throttle bracket (7).
4
Tighten nut (5).
5
Insert threaded segment of adapter (3) into lever extension (4).
6
Install lockwasher (2) and nut (1). Tighten nut.
2-91
|
