|
| |
TM 5-4320-35-24
3-6. REPLACE ENGINE ASSEMBLY (Continued)
INSTALLATION:
WARNING
Death or serious injury could occur if unauthorized or unnecessary
personnel are in the hoisting area. Permit only person- nel actually
engaged in the hoisting operation to be near the unit and hoisting
equipment. All instructions for the hoisting operations must come
from one authorized person.
Injury to personnel or damage to equipment could occur from
improper hoisting. Hoist the load slowly to avoid tearing out lifting
bail assembly, slipping slings, or load shift. Do not jerk the load or
swing it from side-to-side when hoisting. This places additional.
stress on hoisting components which can cause failure and loss of
load. Be sure hoisting equipment is on solid footing and is suitable
for the size of the load. Watch boom angle and overhead clearance
when hoisting.
1
Position a suitable lifting device (1) equipped with a spreader bar and sling over flywheel end of new engineassembly
(2).
2
Place sling under crankcase at flywheel end of engine assembly.
3
Put tension on sling and position spreader bar so that sling hangs vertically and does not crush components mounted
on engine. Make sure engine is properly supported.
4
Only lift the engine high enough to install front engine supports (14) on the engine crankcase.
5
Using screws (19), secure front engine supports (14) to the engine crankcase.
6
Position another suitable lifting device (1) equipped with a spreader bar andsling over blower end of
engine assembly (2).
7
Place sling under crankcase at blower end of engine assembly.
8
Put tension on sling and position spreader bar so that sling hangs vertically and does not crush components mounted
on engine. Make sure engine is properly supported.
9
Only lift the engine high enough to install engine support (3) on the engine front cover.
10 Using screws (11), lockwashers (12), and washers (13), secure engine support (3) to the front cover.
3-23
|
