|
| |
TM 5-4320-305-24
2-42. REPLACE FUEL TANK LINES AND FITTINGS (Continued)
9 Loosen line nuts (1) on injectors (2) one full turn.
10 Hold a lint-free cloth below injectors (6) to collect
leakage.
CAUTION
To prevent starter from overheating, do not
crank engine with starter for more than 10
seconds.
Battery life will be lengthened if 60 seconds is
allowed to elapse between starting attempts.
Under any condition, if engine does not start
on initial attempt, allow engine rotation to stop
completely before again engaging starter.
11 Set MODE SELECT switch at MANUAL and set to maximum engine speed.
12 Press and hold in the OIL BY-PASS switch, set START/STOP switch to START, push up STARTER switch and
observe fuel flow from injector fittings until air is cleared from lines. Release OIL BY-PASS switch.
13 Tighten line nuts (1) on injectors (2).
14 Start engine.
2-159
|
