|
| |
TM 5-4320-305-10
Section III. OPERATION UNDER USUAL CONDITIONS
2-4.
ASSEMBLY AND PREPARATION FOR USE
a.
The pumping assembly comes fully assembled, ready for use after attaching the suction and discharge
hoses.
b.
The operator must know how to perform every operation of which the unit is capable. The following
paragraphs contain instructions on starting and stopping the unit, operation of the pump assembly, and coordinating the
basic motions to perform the specific tasks for which the equipment is designed. Since nearly every job presents a
different problem, the operator may have to vary given procedures to fit an individual job.
2-5.
INITIAL ADJUSTMENTS AND DAILY CHECKS
a.
Be sure that parking brakes are set. Pull
hand brake lever (1) toward the front end of the trailer.
b.
Loosen studs on control panel cover door. Lift door.
c.
Position controls as follows:
(1)
SET POINT switch (1) to OFF
position; turn all the way to the left.
(2)
MODE SELECT switch (2) up in
MANUAL position.
(3)
Engine START/STOP switch (3) down
at STOP position.
2-65
|
