|
| |
TM 5-4320-304-14
TM 08922A-14/1
3–2.
LUBRICATION (Continued)
Do not overfill. Engine damage could result. If overfilled, notify
organizational maintenance.
b. If oil coating is below top mark (2), remove oil cap (3) and add oil of proper viscosity required by ambient
temperature. See following chart.
c. Again check oil level to be sure oil coats dipstick (1) to top mark (2). Check that cap (3) is tightly closed.
Section II. TROUBLESHOOTING PROCEDURES
3-3.
TROUBLESHOOTING
a. Table 3–1 lists common malfunctions which you may find during operation or maintenance of the
centrifugal pump unit or its components. You should perform the tests/inspections and corrective actions in the
order listed.
b. This manual cannot list all malfunctions that may occur, nor all tests or inspections and corrective actions. If
a malfunction is not listed or is not corrected by listed corrective actions, notify your supervisor.
3-2
Change 1
PIN: 062579-001
|
