|
| |
Section IV. OPERATION UNDER UNUSUAL
2-6. OPERATION IN COLD
TM 5-4320-304-14
TM 08922A-14/1
CONDITIONS
a. Use proper engine oil for cold weather. See lubrication instructions in Chapter 3.
Death or serious injury could occur if fuel is not handled
carefully. Use in a well-ventilated area away from open
flame, arcing equipment, ignition sources, heaters, or exces-
sive heat. Engines must be turned off and cool before re-
fueling. Use proper refueling procedures and equipment to
avoid spillage. Do not run engines near open fuel containers.
Always store fuel in proper, marked containers. DO NOT
SMOKE.
b. Keep fuel tank full to prevent condensation. Condensation can freeze and clog lines, filters,
and injectors.
c. Cold weather starting can be improved by the addition of engine oil to the cold start assist.
(1)
(2)
(3)
(4)
With engine stopped, remove closing plug (1) from cold start assist (2).
Engine lockup could occur if oil is poured into center of cold
start assist. Take care to fill cold start assist cup from the side.
Fill cold start assist cup with clean engine oil. To prevent engine lockup, carefully pour oil
in the side of the cup.
Replace closing plug (1) into cold start
assist (2) and press it in firmly.
Start engine immediately using instructions
in paragraph 2-4.
2-31
|
