|
| |
TM 5-4320-304-14
TM 08922A-14/1
CHAPTER 6
INTERMEDIATE GENERAL SUPPORT MAINTENANCE INSTRUCTIONS
Section I. TROUBLESHOOTING
No troubleshooting procedures are required.
Section II. MAINTENANCE PROCEDURES
INDEX
Camshaft
Connecting rod
Crankcase
Crankshaft
Cylinder head and valve assembly
6-1. GENERAL INSTRUCTIONS
Para
6-4
Governor
6-3
Oil seal
6-8
Timing cover
6-7
Valves
6-2
Para
6-5
6-6
6-4
6-2
Most maintenance instructions in this section will list resources required, personnel required, and
equipment condition for the start of the procedure. Note the following:
l
Resources required are not listed unless they apply to the procedure.
l Personnel required are listed only if the task requires more than one. If PERSONNEL is not
listed, it means one person can do the task.
l The normal standard equipment condition to start a maintenance task is engine stopped.
EQUIPMENT CONDITION is not listed unless some other condition is required.
l
Refer to Appendix F to determine torque requirements when tightening threaded fasteners,
unless a specific torque value
determined by thread size.
is given in procedure. Standard torque values given in Appendix F are
6-1
|
