|
| |
TM 5-4320-304-14
TM 08922A-14/1
5-10. lNSPECT/REPLACE CYLINDER HEAD AND VALVE ASSEMBLY (Continued)
2
3
4
5
i. Subtract reading on dial gage that was recorded from the required clearance of 0.0217/0.0256
inch (0.55/0.65 mm). This difference is the thickness of the gasket needed for proper cylinder
head clearance.
NOTE
Gaskets come in various thicknesses. If you have a choice
between two gaskets, it is best to use the thickest one.
j. Remove dial gage 612 087 00 with measuring device 603 114 00, and retaining bracket
612
752
00.
Adjust complete push rod (1) so dimension A equals 5.8189/5.8268
inches (147.8/148.0 mm). This adjustment is required for proper
engagement of complete pushrod with pinion on decompression
shaft.
Install preformed packings (4), shims (5), pressure
springs (6), and protection tubes (3).
Install complete pushrod (2) closest to injection
pump side of engine.
Install pushrod (1).
5-30
|
