Section XVII. ACCESSORY DRIVE SHAFT, FLYWHEEL HOUSING AND REAR OIL SEAL

TM 5-4320-243-15

Figure 7-21. Front end plate, camshaft thrust plate and camshaft, removal and installation

Section XVII. ACCESSORY DRIVE SHAFT, FLYWHEEL HOUSING AND REAR OIL SEAL

7-49. General

accessory drive shaft transfers the motive power of the

The flywheel housing is mounted at the rear of the

engine to the engine coupling.

cylinder assembly. It provides a protective cover for the

flywheel and is used as a mounting base for the starting

7-50. Accessory Drive Shaft

motor and rear engine support. The accessory drive

a. Remove and install the engine (para 5-13).

shaft is mounted to the center of the flywheel. The

b. Remove and install the accessory driveshaft in

engine coupling mounts on the rear end of accessory

sequence as shown by figure 7-22.

drive shaft, and is connected to the pump coupling. The

c. Clean, inspect, and repair.

7-26

TM 5-4320-243-15