Figure 6-10. Manifolds-exploded view.

Figure 6-10. Manifolds-exploded view.

(5) Withdraw push rods and tag or otherwise

d. Cleaning, Inspection, and Repair.

mark so that each rod may be replaced in

its own tappet.

(1) Wash the cylinder head in an approved

(6) Disconnect ignition leads from spark

cleaning solvent; dry with clean, dry, compressed air.

plugs.

(7) Remove capscrews which fasten cylinder

(2) Carefully scrape or wire-brush all carbon

head to cylinder block.

deposits from the cylinder head, cylinder block, valves,

(8) Remove cylinder head and gasket.

and the top of the pistons. Make sure that all loose

carbon is removed to prevent it from getting into the

c. Disassembly.

Refer

and

water passages and engine oil.

disassemble cylinder head.

6-11