 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-4320-237-25P
SECTION I
INTRODUCTION
Code
Explanation
1. Scope
P
Applied to repair parts which are stocked
This manual contains a list of repair parts
in or supplied from DSA/GSA or Army
required for the performance of organizational,
supply system, and authorized for use
direct support, general support, and depot
at indicated maintenance categories.
maintenance of the pump.
Applied to repair parts which are not pro-
xl
cured or stocked, the requirement for
which will be supplied by use of the
2. General
next higher assembly or components.
This repair parts list is divided into four
Applied to repair parts which are not
X2
stocked. The indicated maintenance
principal sections and a Federal stock number
category requiring such repair parts
index.
will attempt to obtain them through
cannibalization; if not
obtainable
through cannibalization, such repair
List ( PLA), is a consolidated listing of repair
parts will be requisitioned with support-
parts quantitatively allocated for initial stock-
ing justification through normal supply
age at the organizational level. This is a manda-
channels.
tory minimum stockage allowance.
Note. Source code is not shown on
common hardware items known to be
readily available in Army supply chan-
of repair parts authorized for the performance
nels and through local procurement.
of maintenance at the organizational level. No
( 2 ) Maintenance Code indicates the lowest
special tools are required for this end item
category of maintenance authorized to
c. Section IV, Repair Parts List, is a list
install the listed item. The mainte-
of repair parts authorized for the performance
nance level codes are:
of maintenance at the direct suppot, general
support, and depot level.
Code
Explanation
o
Organizational maintenance
d. Section V, Federal Stock Number and
Direct support maintenance
F
Manufacturer's Part Number Index, is an index
General support maintenance
H
of Federal stock numbers and manufacturer's
Depot maintenance
D
part numbers to page and manufacturer's codes.
(3) Recoverability Code indicates whether
unserviceable items should be re-
3. Explanation of Columns
turned for recovery or salvage. Items
not coded are expendable. Recover-
The following provides an explanation of
columns in the tabular lists.
ability code is:
a. Source, Maintenance, and Recoverability
Explanation
Code
Codes.
Applied to repair parts and assemblies
R
which are economically repairable at
(1) Source Code indicates the selection
DSU and GSU activities and normally
status and source for the listed item.
are furnished by supply on an exchange
Source codes used are:
basis.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals