Quantcast Cleaning and Inspection. - TM-5-4320-234-340098

 

Click here to make tpub.com your Home Page

Page Title: Cleaning and Inspection.
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Back
Figure 6-2. Chassis frame, exploded view.
Up
TM-5-4320-234-34 Pump Centrifugal Self-Priming Gasoline Engine Driven Wheel Mounted 6-Inch 1500 GPM Capacity At 60 Foot Head Manual
Next
APPENDIX A. REFERENCES - TM-5-4320-234-340099
TM 5-4320-234-34
(5) Be sure that all remaining parts are
b. Cleaning and Inspection.
present and in good condition. Replace any missing or
damaged parts.
WARNING
(6) Inspect the chassis frame for cracks,
Clean all parts in a well-ventilated
distortion, or broken weldments. Minor straightening of
area.  Avoid inhalation of solvent
the frame is permitted. Repair cracked weldments using
fumes and prolonged exposure of
arc welding methods. Replace the frame if it is severely
skin to cleaning solvent.
Wash
damaged.
exposed  skin  thoroughly.
Dry
cleaning solvent (Fed.  Spec. P-D-
(7) If paint is damaged in any way, remove
680) used to clean parts is potentially
damaged paint and sand the areas smooth. Prime and
dangerous
to
personnel
and
repaint the bare areas.
property.  Do not use near open
flame or excessive heat. Flash point
c. Reassembly and Installation.
of solvent is 100 F. to 138 F. (38 C. to
59 C.).
(1) Reassemble the chassis frame as shown
(1) Steam-clean the chassis frame and its
related parts.
If steam-cleaning equipment is not
(2) Install the axle and suspension system
available, flush off the chassis frame with a water-
pressure hose. Remove greasy and gummy deposits
with cleaning solvent (Fed. Spec. P-D-680).
(3) Install the wheel and hub assembly (TM
5-4320-234-12, para 4-52).
(2) Inspect spring bumpers (19, fig. 6-2) for
cracks, wear, and deterioration; replace if defective.
(4) Install the engine (para 2-11).
(3) Check the fit of the stands (36) in the
(5) Install the pump and bearing housing
sleeves mounted on the frame. The stands must slide
easily through the sleeves.
(6) Install the battery box and tool box (TM
(4) Inspect the front leg (30) and related
5-4320-234-12, para 4-54).
parts for distortion, cracks, and damage.
Minor
straightening of the leg is permitted. Replace defective
(7) Install the fuel tank (TM 5-4320-234-12,
parts and parts damaged beyond repair.
para 4-22).
6-5

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc.