|
| |
TM 5-4320-228-13&P
2-6.
STOPPING THE EQUIPMENT.
To stop pumping operation:
1 - Place the throttle control in the idle position, and let the
engine idle for 3 to 5 minutes.
This will allow the engine
to cool.
2 - Set the Ignition Switch to OFF.
2-7.
DISMANTLING FOR MOVEMENT.
The pump is completely self-contained and can be moved over short,
distances manually by lifting at the ends of the pump frame.
If the
pump is to be transported by carrier, block or tie it to the carrier to
prevent it from shifting while being transported.
When tying pump to carrier, install bands
through frame.
Do not secure by banding
across channels.
a.
Disconnect inlet and outlet hoses from inlet and outlet
adapters.
b.
Disconnect exhaust pipe extension if used.
2-12
|
