SECTION I. INTRODUCTION - TM-5-4320-220-35P0005

TM 5-4320-220-35-P

SECTION I.

INTRODUCTION

1. Scope

Applied to repair parts which are not pro-

cured or stocked but are to be manufactured at

This manual lists repair parts required for the

indicated maintenance categories.

performance of direct support, general support, and

Applied to assemblies which are not

depot maintenance of the pump.

2. General

procured or stocked as such but made up

of two or more units, each of which carry

a. The repair parts list is arranged as follows:

individual

stock

numbers

and

(1) Individual parts and major assemblies are

descriptions and are procured and

listed alphabetically by item name within the numbered

stocked and can be assembled by units

functional groups.

at indicated maintenance categories.

(2) Assembly components and subassemblies

Applied to parts and assemblies which are

are indented and listed alphabetically by item name

not procured or socked, the mortality of

under major assemblies.

which is normally below that of the

b. This Repair Parts and Special Tools List Is

applicable end Item, and the failure of

divided into the following sections:

which should result in retirement of the

(1) Repair Parts-Section II. A list of repair

end item from the supply system.

parts authorized for the performance of maintenance at

Applied to repair parts which are not

the direct support, general support, and depot level.

procured or stocked, the retirement for

(2) Special Tools, Test and Support Equiment

which will be supplied by use of the next

Section IlI. A list of special tools, test and support

higher assembly or components

equipment authorized for the performance of

Applied to Sir parts which are not stocked.

maintenance at the direct support, general support, and

The indicated maintenance category

depot level. Not applicable.

requirement such repair parts will

(3) Federal Stock Number and Reference

attempt to obtain them through

Number Index: Section IV. A list of Federal stock

cannibalization; if not obtainable though

numbers followed by reference numbers in ascending

cannibalization, such repair parts will be

alpha-numeric sequence cross-referenced to index

requisitioned with supporting justification

number.

3. Explanation of Columns

through normal supply channels.

Applied to major assemblies that are pr

The following provides an explanation of columns in the

cared with PEMA

(Procurement

tabular lists in sections II and III:

Equipment Missile Army) funds for initial

a. Source, Maintenance, and Recoverability Codes

issue only to be used as exchange

(SMR), Column (1):

assemblies

DSU

and

GSU

(1) Source Code, indicates the selection status

maintenance level. These assemblies

and source for the listed item. Source codes used are:

will not be stocked above DSU and GSU

level or returned to depot supply

Code

Explanation

level.

Applied to repair parts which are

Note. Source code is not shown on

stocked in or applied from

common hardware items known to be

DSA/GSA or Army sup ply system.

readily available in Army supply

and authorized for use at indicated

channels ad through local procurement.

maintenance categories

(2)

Maintenance Code, indicates the lowest

category of maintenance authorized to install the listed

item. The maintenance level codes are:

Code

Explanation

0rganational maintenance

Direct support maintenance

General support maintenance

Depot maintenance

iii