|
| |
TM 10-8110-203-12&P
4-12. REPAIR TOWING AND LIFTING YOKE.
This task covers:
(a) disassembly
(b) cleaning
(c) inspection
(d) assembly
INITIAL SETUP
Tools:
Tool Kit, General Mechanics: ( Item 1, Appendix B, Section III)
Equipment Condition:
Towing and Lifting Yoke removed from drum.
Materials/Parts:
Dry leaning Solvent (Item 3, Appendix F, Section II)
Rag, wiping: (Item 2 Appendix F, Section II )
(Refer to Figure 4-4).
NOTE
Repair is limited to replacement of parts found defective during inspection.
a. Disassembly
1. Remove two s-hooks (1) and two clevis pin assemblies (2).
2. Remove two screws (3) and two lock nuts (4) from braces (5).
3. Remove two screws (6) and two lock nuts (7) and then remove two braces (5) from two connecting
legs (8).
4. Remove two set screws (9) and two pins (10) and then remove two connecting legs (8) from two
upper legs (11).
b. CIeaning
1. Remove all buildup of dirt, oil and debris from all mating surfaces.
WARNING
DO NOT breathe dry cleaning solvent vapors for long periods of time or allow solvent to come into
contact with skin for an extended time. DO NOT use solvent near open flames or excessive heat.
2. Clean all metallic parts with a clean wiping rag (Item 2 Appendix F and cleaning solvent (Item 3.
Appendix F) and allow parts to dry.
4-9
|
