|
| |
TM 10-6630-247-13&P
2-12. PREPARATION FOR MOVEMENT - cont.
Disassemble Flash Point Tester. Refer to figure 2-17.
(5)
Disconnect electrical cord (14) from power cable (13).
(6)
Disconnect power cable (13) from power source.
(7)
If removed, install flash cup (15) as follows:
(a)
Place flash cup (15) in top plate (16).
(b)
Position cover assembly (17) over flash cup (15).
(c)
Rotate cover assembly (17) so that notches in cover are positioned under knobs
(18).
(d)
Tighten two knobs (18).
(8)
Close gas line needle valve (2) and cylinder valve (5).
(9)
Disconnect rubber tubing (7) from cylinder valve (5) and gas line fitting (8).
(10) Remove cylinder valve (5) from propane cylinder (6).
d.
Pack-Up Cabinet Assembly.
Pack Components. Refer to figure 2-18.
(1)
Clean required components with clean, soapy water and wiping rags.
(2)
Stow all test kit components in the cabinet as shown on the loading plan.
Assemble Cabinet. Refer to figure 2-19.
(3)
Fold right table top (12) over onto top of cabinet (1).
(4)
Fold left table top (13) over onto top of cabinet (1).
(5)
Fasten table top latch (11).
(6)
Close left door (10), then right door (9).
2 - 3 4
|
