|
| |
TM 10-6630-247-13&P
Section III. OPERATION UNDER USUAL CONDITIONS
2-7. ASSEMBLY AND PREPARATION FOR USE.
a.
Site Selection. Site selection must consider availability of electrical power and access to fuel
storage facilities. The test kit should be setup in a tent or shelter to protect test equipment and
fuel samples from wind, dust, rain, or snow. The site should be as level and dry as possible.
b.
Setup Cabinet Assembly. Refer to figure 2-5.
(1)
Pull out carrying handles (1) from both sides of cabinet (2).
(2)
Remove detent pins (3) securing legs (4) to cabinet (2).
WARNING
The test kit is heavy and can be difficult to handle. Four personnel are
required to lift and transport the test kit to prevent injury to personnel
and damage to the equipment. A fifth person is required to lower the legs
of the cabinet while cabinet is held up off ground.
(3)
Using four personnel, lift cabinet (2) off ground.
WARNING
To prevent injury to personnel and damage to the equipment, leg braces
must be locked in the down position before releasing weight of cabinet
onto legs. Cabinet may fall if braces are not securely locked.
(4)
Pull legs (4) down from cabinet (2) until fully extended. Make sure braces (5) are straight
and securely locked.
(5)
Unlock barrel bolts (6) and adjust leveling legs (7) up or down as required to level cabinet.
Lock barrel bolts into leveling legs when adjustment is complete. Lower cabinet (2) to
ground.
(6)
Unlock right door handle (8). Fully open left and right doors (9 and 10).
(7)
Unfasten table top latch (11).
(8)
Unfold left table top (12) down onto left door (10).
(9)
Unfold right table top (13) down onto right door (9).
2-13
|
