|
| |
TM 10-5430-242-12&P
0033 01
0033 01-1
Change 1 – 28 April 2002
OPERATOR AND UNIT MAINTENANCE MANUAL
(INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
COLLAPSIBLE FABRIC TANKS, FUEL STORAGE, 3,000,
10,000, 20,000, AND 50,000 GALLON
BERM LINER DRAIN FITTING ASSEMBLY (MPC MODEL)
SERVICE AND REPAIR
INITIAL SETUP
Tools
Equipment Condition
Tool Kit, General Mechanics
Berm liner drain hose assembly removed
(Item 1, WP 0036 00)
(WP 0031 00)
Materials/Parts
Mandatory Replacement Parts
Detergent
Gasket
(Item 6, WP 0042 00)
(Item 3, WP 0044 00)
Dry Cleaning Solvent
Gasket
(Item 7, WP 0042 00)
(Item 14, WP 0044 00)
Rags, Wiping
O-ring
(Item 2, WP 0042 00)
(Item 15, WP 0044 00)
DISASSEMBLY
1. Disconnect chain assembly (1) from male disconnect coupling (2) and dust cap (3).
2. Remove from male disconnect coupling (2) by pulling outward on cam-lever arms (4) and lifting dust
cap (3) from coupling (2). Remove and discard gasket (5) from dust cap (3).
3. Remove coupling (2), shim washer (6), gasket (7), and o-ring gasket (8) from berm liner drain (9).
SERVICE
WARNING
Dry cleaning solvent, A-A-59601, used to clean parts, is potentially dangerous to
personnel and property. It produces toxic and flammable fumes. Use only in well
ventilated areas. Avoid repeated and prolonged skin contact. Do not use solvent
near an open flame or near excessive heat. The flash point of the solvent is 100F
to 130F (38C to 59C).
CAUTION
Dry cleaning solvent, A-A-59601, used to clean parts, must not come into contact
with any part of the fuel tank fabric. Damage to the fabric will occur.
1. Clean all parts with dry cleaning solvent and dry thoroughly with rags.
2. Inspect all parts for cracks, dents, breaks, and wear. Replace the component if unserviceable.
|
