|
| |
TM 10-5430-242-12&P
0028 00
0028 00-3/4 blank
Change 1
ASSEMBLY
1. Install new gasket (16) into dust cap (17).
2. Install new elbow gasket (4) into 4-inch elbow (1).
3. Place suction stub (14) on a hard, flat surface with the eight bolt holes positioned up.
4. Position new gaskets (13) over each bolt hole in suction stub (14).
5. Position closure plate (7), on top of new gaskets (13), and align holes.
6. Position new flanged adapter gasket (15) on closure plate (7), and align the holes.
7. Position flanged adapter (3) on gasket (15), and align the holes.
NOTE
MPC Model Tanks use an additional eight gaskets on the screws for mounting the
suction stub.
8. Install screws (12) and new gaskets (13) (if required) through the holes in flanged adapter (3), and
thread screws (12) through until the ends protrude through suction stub (14).
9. Assemble new gaskets (13), new lockwashers (11), and nuts (10) to screws (12). Torque fastening
hardware to 15 ft-lbs (20.34 N m) for Reliance Models and to 16 ft-lb (21.70 N m) for MPC Models.
10. Lubricate new o-ring (9) with silicone compound. Position o-ring (9) into the packing groove.
11. Position closure plate (7) and attached components on the tank. Install closure plate (7) and attached
components through the opening in the tank, until closure plate (7) contacts tank fitting (8).
NOTE
If the tank is lying completely flat, lift the tank to the closure plate to begin threading the
screws through the tank fitting.
12. Assemble washers (6) onto screws (5). Install screws (5) through closure plate (7) and tank fitting
(8).
13. Torque fastening screws (5) to 15 ft-lbs (20.34 N m) for Reliance Models and to 16 ft-lb (21.70 N m)
for MPC Models.
14. Position elbow (1) on flanged adapter (3), and push cam-lever arms (2) inward, locking elbow (1) to
flanged adapter (3).
END OF WORK PACKAGE
|
