|
| |
TM 10-5430-242-12&P
0027 00
0027 00-3/4 blank
ASSEMBLY
1. Install new gasket (15) into dust cap (16).
2. Install new elbow gasket (4) into 4-inch elbow (1).
3. Position new flanged adapter gasket (14) on closure plate (7), and align the holes.
4. Position flanged adapter (3) on flanged adapter gasket (14), and align the holes.
5. Install screws (12) through the holes in flanged adapter (3), and thread screws (12) through.
6. Assemble new gaskets (13), new lockwashers (11), and nuts (10) to screws (12). Torque the
fastening hardware to 16 ft-lbs (21.70 N m).
7. Lubricate new o-ring (9) with silicone compound. Position o-ring (9) into the packing groove.
8. Position closure plate (7) and attached components on the tank. Install closure plate (7) and attached
components through the opening in the tank, until closure plate (7) contacts tank fitting (8).
NOTE
If the tank is lying completely flat, lift the tank to the closure plate to begin threading the
screws through the tank fitting.
9. Assemble twenty washers (6) onto screws (5). Install screws (5) through closure plate (7) and tank
fitting (8).
10. Torque fastening screws (5) to 16 ft-lbs (21.70 N m).
11. Position elbow (1) on flanged adapter (3), and push cam-lever arms (2) inward, locking elbow (1) to
flanged adapter (3).
END OF WORK PACKAGE
|
