|
| |
TM 10-5430-236-12&P
0020 00
0020 00-1
UNIT MAINTENANCE
FILLER ASSEMBLY
REPLACEMENT AND REPAIR
INITIAL SETUP
Tools
General Mechanics, Tool Kit
(Item 1, WP 0030 00)
Torque Wrench, 0-300 in-lb
(Item 2, WP 0030 00)
Materials/Parts
Detergent, General Purpose
(Item 3, WP 0034 00)
Rag, Wiping
(Item 2, WP 0034 00)
Silicone Compound
(Item 4, WP 0034 00)
Mandatory Replacement Parts
Gasket
(Item 4, WP 0037 00) (two required)
Gasket
(Item 6, WP 0037 00)
Lockwasher
(Item 5, WP 0037 00) (eight required)
Preformed Packing
(Item 7, WP 0037 00)
Packing with Retainer
(Item 8, WP 0037 00) (eight required)
General Safety Instructions
WARNING
Do not smoke within 100 feet (30.5m) of tanks.
Fuel is toxic to skin, eyes, and respiratory tract.
REMOVAL
Open locking arms (1) on filler elbow (2). Separate filler elbow (2) from flanged coupling half (3).
DISASSEMBLY
1. Remove two gaskets (4) from filler elbow (2). Discard gaskets (4).
2. Remove twenty screws (5), flat washers (6), and dust cap (7) with chain assembly (8) from
compression plate (9).
3. Separate compression plate (9) and attached parts from tank compression fitting (10). Remove
preformed packing (11). Discard preformed packing (11).
4. Remove eight nuts (12), lockwashers (13) and suction stub (14). Remove eight packings with retainers
(15), screws (16), flanged coupling half (3), and gasket (17) from compression plate (9). Discard
gasket (17), lockwashers (13), and packings with retainers (15).
5. Remove gasket (18) from dust cap (7). Discard gasket (18).
6. Remove chain assembly (8) and key holder (19) from dust cap (7).
CLEANING
1. Clean all components with clean water and detergent.
2. Rinse components in clean water and dry with wiping rag.
|
