|
| |
TM 10-5430-1232-12&P
SERVICE
WARNING
Cleaning solvent, P-D-680, used to clean parts, Is potentially dangerous to
personnel and property. It produces toxic and flammable fumes. Use only In well-
ventilated areas. Avoid repeated and prolonged skin contact. Do not use near an
open flame or excessive heat. The flash point of solvent Is 100°F to 138°F (38
C
to 59
C).
1 Clean all parts with cleaning solvent and dry thoroughly.
2 Clean out packing grooves thoroughly with cleaning compound and hot water.
3 Inspect all mechanical parts for cracks, dents, breaks, or wear. Replace or repair if unserviceable.
4 Carefully inspect gaskets and packing for deterioration, distortion, cracks, or breaks. Replace when
serviceability is doubtful.
ASSEMBLY (See figure 4-8)
1 Place gasket (14) into dust cap (15).
2 Place elbow gasket (4) into elbow (1).
3 Place suction stub (1 2) on flat hard surface with bolt holes on top.
4 Place one flange gasket (13) on the suction stub (12) and align the bolt holes.
5 Place closure plate (7) on top of suction stub (12) and flange gasket (13) being careful to keep all
holes aligned.
6 Place the other Mange gasket (13) on dosure plate (7) and align holes.
7 Place flanged adapter (3) on flange gasket (13) and align holes. Place flat washers (11) over
holes in flanged adapter (3).
8 Insert screws (10) through holes in flanged adapter (3) and torque to 10 ft.-lbs. (14 N m).
9 Lubricate preformed packing (9) with silicone compound and place in packing groove in collapsible
tank fitting.
10 Place closure plate (7) and attached components on tank and insert suction stub (12) through
opening in tank until closure plate (7) contacts tank fitting (8).
11 Place flat washers (6) over holes in closure plate (7). If tank is lying completely flat, lift tank
to closure plate (7) to start screws (5) in tank fitting (8).
12 Torque to 30 in-lb (3.41 N m).
13 Place elbow (1) on flanged adapter (3). Pull inward on cam-lever arms (2) to lock items together.
Change 1 4-20
|
