|
| |
TM 10-4930-250-13&P
2
5
4
1
10
11
6
8
12
13
3
4
9
Figure
4-10.
Repair
of Two
Inch Non-Valved
Unisex
Coupling
NOTE
Do not remove
continuity
ball (12) from unisex coupling
body.
If continuity
ball requires
replacement,
the
entire unisex coupling must be replaced.
b.
Assembiv.
Rubber gloves should be worn when handling fueling system components due to the toxic effects of
some fuel additives.
(1) Install locking pin (10) and spring (11).
(2) Install lugs (7 and/or 8) with screws (9).
(3) Install bumper (6) onto coupling body such that the tapered edge is facing the unisex coupling (2) body.
(4) Attach cable (4) to dust cap (3) by looping about 6 inches of cable through the hole in dust cap (3) forming a loop
back on the cable (4). Install and crimp a sleeve (13) over the two sections of cable (4).
(5)If cable (4) was cut, attach cable (4) to split ring (5) by looping about 6 inches of cable through the ring (5) forming
9
8
a loop back on the cable (4). Install and crimp a sleeve (13) over the two sections of cable (4).
If cable (4) was not
cut, attach to split ring (5) by rotating split ring (5) through cable (4) loop.
(6) Install spring (1) in unisex coupling (2).
4-26
|
