|
| |
TM 10-4930-248-13&P
4-10.
CCR NOZZLE ASSEMBLY REPAIR.
This task consists of:
a. Disassembly
b. Repair
c. Assembly
INITIAL SET-UP:
Tools:
Equipment Condition:
Tool kit, General Mechanics (Item 1, Appendix B)
CCR Nozzle removed from fuel system.
Vise (Item 2, Appendix B)
(Reference Applicable System TM)
General Safety Requirements:
Materials/Parts
Required:
Solvent (Item 1, Appendix F)
WARNINGS
Wiping Rag (Item 2, Appendix F)
• Fuels are toxic and flammable.
Do not get on
Silicone Compound (Item 3, Appendix F)
person or clothing. Do not use near open flame.
Sealing Compound (Item 4, Appendix F)
Area should be well-ventilated.
Packing, Preformed (Item 1, Appendix J)
• Using drycleaning solvents incorrectly can cause
Gasket, Coupling (2) (Item 8, Appendix J)
injury or even death.
• Fuel is flammable.
Do not smoke.
a.
Disassembly.
(1)
Pull the nozzle collar (1) back to release the cap (2) from the discharge end of the nozzle.
Remove the cap (2).
(2)
Remove screw (3) holding the ground cable assembly (4) and cap assembly cable (2) to the
nozzle housing (5).
(3)
Remove strainer body (6) and attached coupling assembly (10) from strainer housing (7).
(4)
Remove strainer (8) and preformed packing (9) from strainer housing (7). Discard
packing.
(5)
Place strainer body (6) into a soft face vise.
(6)
Unscrew coupling assembly (10) from strainer body (6).
(7)
Remove dust cover (11) from coupling half (13).
(8)
Remove gasket (12) from coupling half (13).
(9)
Remove gasket (14) from dust cover (11).
4-8
|
