|
| |
TM 10-4930-242-13&P
i.
Repair.
The
application
of
maintenance
services1
including
fault
location/troubleshooting2,
removal/installation, and disassembly/assembly3 procedures, and maintenance actions4 to identify troubles and restore
serviceability to an item by correcting specific damage, fault, malfunction, or failure in a part, subassembly, module
(component or assembly), and item, or system.
j.
Overhaul. That maintenance effort (service/action) prescribed to restore an item to a completely
serviceable/operational condition as required by maintenance standards in appropriate technical publications (i.e.,
DMWR). Overhaul in normally the highest degree of maintenance performed by the Army. Overhaul does not normally
return an item to like new condition.
k.
Rebuild Consists of those service/actions necessary for the restoration of unserviceable equipment to a like-
new condition in accordance with original manufacturing standards. Rebuild is the highest degree of material
maintenance applied to Army equipment. The rebuild operation includes the act of returning to zero those age
measurements (hours, miles, etc. ) considered in classifying Army equipment and components.
B-3. EXPLANATION OF COLUMNS IN THE MAC. SECTION II.
a.
Column 1 - Group Number Column 1 lists functional group code numbers, the purpose of which is to identify
maintenance significant components, assemblies, subassemblies, and modules with the next higher assembly.
b.
Column 2 - Component/Assembly. Column 2 contains the names of components, assemblies,
subassemblies, and modules for which maintenance is authorized.
c.
Column 3 - Maintenance Function. Column 3 lists the functions to be performed on the item listed in column
2. (For detailed explanation of these functions, see paragraph B-2.)
d.
Column 4 - Maintenance Category. Column 4 specifies, by the listing of a work time figure in the appropriate
subcolumn(s), the category of maintenance authorized to perform the function listed in Column 3. This figure represents
the active time required to perform that maintenance function at the indicated category of maintenance. If the number or
complexity of the tasks within the listed maintenance function varies at different maintenance categories, appropriate
work time figures will be shown for each category. The work time figure represents the average time required to restore
an item (assembly, subassembly, component, module, end item, or system) to a serviceable condition under typical field
operating conditions. This time includes preparation time (including any necessary disassembly/assembly time),
troubleshooting/fault location time, and quality assurance/quality control time in addition to the time required to perform
the specific tasks identified for the maintenance functions authorized in the maintenance allocation chart. The symbol
designations for the various maintenance categories are as follows:
C
Operator or Crew
O
Unit Maintenance
F
Direct Support Maintenance
H
General Support Maintenance
D
Depot Maintenance
1Service - Inspect, test, service, adjust, aline, calibrate, and/or replace.
2Fault location/troubleshooting - The process of investigating and detecting the cause of equipment
malfunctioning; the act of isolating a fault within a system or unit under test (UUT).
3Disassembly/assembly - The step-by-step breakdown (taking apart) of a spare/functional group coded item to the
level of its least component, that is assigned as SMR code for the level of maintenance under consideration (i.e.,
identification as maintenance significant).
4Actions - Welding, grinding, riveting, straightening, facing, machining, and/or resurfacing.
B-2
|
